Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

ERIC DOMINGO

Joined on the:

Jan. 13, 2019

Score

290

Comment(s)

3

Voted question(s)

0

Voted answer(s)

2

Votes up

0

Votes down

2

Votes up received

1

Votes down received

0

Recent Activity

Question(s) asked

3

Answered question(s)

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

27/01/2021

 Mazda ERIC DOMINGO (290Pts.)

0

2010 Mazda 6 Standard Key EVO-ONE - Dcryptor Step 5

Hello, For a 2010 Mazda 6 Standard Key (instructions https://cdn02.fortin.ca/download/80571/evo-one_ig_reg_bi_maz_6_2009-2013_key_a_80571.pdf), I can't get the Dcryptor process (specifically step 5) to work for the EVO-ONE. The unit was removed and reinstalled, and I reflashed and master reset the bypass (Flashlink recommended 7.44 and I followed the hold down prog button while connecting 6-pin, then hold down again until all LEDs cycle). When I get to step 5, both the yellow and red LEDs are on and the red LED never turns off to proceed to step 6. If I turn off the ignition, both yellow and red remain on. I have tried the 2 key method and it will not work either. I have resoldered the TX and RX lines on the transponder connector as well. The unit otherwise attempts to remote start the car, but the security light flashes quickly on the dashboard and remote start is not successful, then the parking lights flash 4x after the failed start. Any other suggestions?
Login to reply View 1 answer(s)

19/01/2021

 Mazda ERIC DOMINGO (290Pts.)

0

Old instructions for 2010 Mazda 6

Do you have a copy of the old installation guide for EVO-ONE in a 2010 Mazda 6 Standard Key? I purchased and installed in early 2019 and the unit was manufactured in 2018. The new instructions say the unit has to be manufactured after 2019 but the old instructions didn't have that limitation. I had an unrelated electrical issue with the vehicle and had to disconnect the EVO-ONE and its wiring, and now that I have resolved that, I want to make sure I reinstall in the correct way with the correct firmware versions.
Login to reply View 1 answer(s)

12/03/2019

 Mazda ERIC DOMINGO (290Pts.)

1

Can 2010 Mazda 6 rear defroster be controlled via Canbus with EVO-ONE?

Wondering if the CANBUS can be used to control the rear defroster over AUX2 on the EVO-ONE for a 2010 Mazda6, and if so if there's a setting in FlashLink that should be enabled. I don't want to pull the unit back out of the car if it isn't even possible. If it's not possible for this car, I'd like to know if the (-) Ignition green wire on the 20 pin connector is available for use--if so, I should be able to wire it to a 12V thermostat cooling relay (something like this https://www.amazon.com/RioRand-Thermostat-Temperature-Controller-Waterproof/dp/B00KCCX0EE) to send ground through the relay based on temperature. Thanks!
Login to reply View 1 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue